Tag Archives: Upcycling

Pressure Gauge Table Clock

Standard

imageSo one of my hobbies is exploring old and abandoned places. Occasionally I collect trinkets on these visits, this pressure gauge being one of them. It very conveniently screws on and off any threaded pipe of the correct size. Once I got it home, I decided that I was particularly fond of the metered gauge face, and I decided to convert it into a clock. The front clear cover easily popped off, and the metal face comes off with the removal of some tiny screws. The heavy construction, or should I say deconstruction, came with taking out the insides of the pressure gauge. This is to make room for the clock parts that would be added later. This part of the process is dependent on sheer brute strength. ¬†Once you pull, twist, and bend the metal insides enough, they just sort of break off. I bought hands of the clock from Michaels. They run about $5, depending on the size. Make sure you purchase hands that will fit the diameter of your pressure gauge. There’s already a hole in the pressure gauge face, and by following simple directions on the packaging, you can attach the clock parts. The face simply reattached with the screws, securing it and the new clock in place, and finally you can reapply the front cover. The design of the base is completely flexible. I just bought a few different metal pipe pieces from Lowe’s, and played around until I got a look that I liked. These pieces aren’t too expensive, but obviously the more pipe, the higher the cost. Drill two holes in an old wooden board, add some stain I had lying around, and you have yourself a base.

 

The only part of this project that proves cumbersome is changing the clock battery. The cover has to be removed, screws unscrewed, and face plate removed to change the batteries.